Reproduced in the original tower style design. Includes all eight clamps needed to completely replace radiator and heater hose clamps. Kit includes: Two 2-1/16" upper radiator hose clamps Two 2-5/16" lower radiator hos e clamps Two 5/8"…
New defroster hose for your Galaxie with correct sizes and original style lining and coil design. Available in three sizes. Please check you inside diameter required an specify when ordering. Made in the usa! Sold by the foot, non…
Steel Braided Hose Kit is the most inexpensive, but eye-catching way to decorate your engine bay for a show cars high quality appearance or to replace the old dirty look of rubber hoses and lines. Simply disconnect one end of each…
The hoses are authentic flex-style and made from original-type polypropylene-coated fabric, and they will guide air up toward your Mustang's windshield. You'll get two hoses, one for the driver side and one for the passenger side. Both…
Our radiator hoses are made to match the original hoses exactly. All hoses are made by gates or goodyear both original suppliers to Ford. They feature correct style ink markings that will not come off and has the correct factory part…
New complete sets of original style heater hose and and radiator clamp sets. These are the original tower and wire band style clamps used by the Ford motor company. The absolute most correct clamps available for restoration. Get the whole…
Tip: Use a crescent type wrench at the square nut to hold it so it and the clamp do not twist when tightening. Then after a few heat cycles repeat. Also, if the bent tabs that are on the clamp are crooked, you may have to…
Our radiator hoses are made to match the original hoses exactly. All hoses are made by gates or goodyear both original suppliers to Ford. They feature correct style ink markings that will not come off and has the correct factory part…
Our radiator hoses are made to match the original hoses exactly. All hoses are made by gates or goodyear both original suppliers to Ford. They feature correct style ink markings that will not come off and has the correct factory part…
Give your engine compartment that special detail witho ur new concours quality reproduction fuel hose clamps. Fits foth 5/16 And 3/8 Fuel lines on all 1968/1973 Rancheros, Fairlanes and Torinos.
…
Corbin clamps like this were used on all 1955, 1956 & 1957 Chevy radiator and heater hoses from the factory and being lightly plated they were very susceptible to rust and corrosion.
…
Corbin clamps like this were used on all 1955, 1956 & 1957 Chevy radiator and heater hoses from the factory and being lightly plated they were very susceptible to rust and corrosion. …
Steel Braided Hose Kit is the most inexpensive, but eye-catching way to decorate your engine bay for a show cars high quality appearance or to replace the old dirty look of rubber hoses and lines. Simply disconnect one end of each…
Best Quality Reproduction Heater Hoses
Black Reinforced Rubber
GM Markings On One Hose Only As Original
5' Of Each 5/8" & 3/4" Hose
For Trucks Without Air Conditioning
The hoses on your Chevrolet Or GMC Truck are…
Restoration Correct Hose Clamp Gold Cad Finish 1-7/8" For Upper Radiator Hose Corbin Pliers Available As Our P/N 88-0369-1 Corbin clamps like this were used on all 1958 Chevy radiator and heater hoses from the factory and being lightly…
Our radiator hoses are made to match the original hoses exactly. All hoses are made by gates or goodyear both original suppliers to Ford. They feature correct style ink markings that will not come off and has the correct factory part…