Tip: Use a crescent type wrench at the square nut to hold it so it and the clamp do not twist when tightening. Then after a few heat cycles repeat. Also, if the bent tabs that are on the clamp are crooked, you may have to…
Corbin clamps like this were used on all 1955, 1956 & 1957 Chevy radiator and heater hoses from the factory and being lightly plated they were very susceptible to rust and corrosion.
…
Corbin clamps like this were used on all 1955, 1956 & 1957 Chevy radiator and heater hoses from the factory and being lightly plated they were very susceptible to rust and corrosion. …
Reproduced in the original tower style design. Includes all eight clamps needed to completely replace radiator and heater hose clamps.
Kit includes:
Two 2-1/16" upper radiator hose clamps
Two 2-5/16" lower radiator hos e…